Sony SAT-T60 - Manual (Page 20)

20
Step 2: Connecting Your TV
Connect your TV to the Satellite Receiver as shown below. 1
2a
2b
2c
If you have a local TV antenna or cable
company service
Connect it to the VHF/UHF IN jack on your
Satellite Receiver using a coaxial cable or RF
adapter (not supplied). You can view local
stations using your TV controls when the
power to the receiver is off.
Note
You must use the VHF/UHF (SAT) OUT jack to
connect to your TV or VCR when a local TV
antenna or cable company service is connected to
the VHF/UHF IN jack (see
below and on
page 21). When the power to the Satellite
Receiver is off, the antenna signal passes through
to your TV.
If your TV has A/V input jacks
Connect the AUDIO/VIDEO OUTPUT
jacks on your Satellite Receiver to the A/V
input jacks on your TV using the supplied
A/V cable. If your TV has only one audio
input, connect it to the AUDIO L jack on the
receiver. (Be sure to match the colors on the
jacks with the colored plugs on the
A/V cable.)
If your TV has an S-Video input
Use the S-Video cable instead of the yellow
video connection shown in
.
If your TV does not have A/V jacks
Connect the VHF/UHF (SAT) OUT jack to
the VHF/UHF input jack on your TV using
coaxial cable.
Notes
• With this connection, your input source is
channel 3 or channel 4 on your TV depending
on how you set the CH 3|4 switch on the
Satellite Receiver.
• If you connect using or , you can connect
your local TV antenna or cable company service
to the TV’s VHF/UHF input directly.
2c 1c
2a
2a 2b
In AC
S-VIDEO
VHF/UHF (SAT) OUT
TEL LINE
SERIAL
AUDIO R
AUDIO L
VIDEO
IR
OUTPUT
ACCESS CARD
SATELLITE IN VHF/UHF IN DIGITAL
AUDIO OUT
(OPTICAL)
CH
3 4
OPTIONAL REQUIRED
POWER OFF
PASS-THRU
ONLY
VHF/UHF
POWER OFF
PASS-THRU
CNTRL
OUT 2 1 2 1
VHF/UHF
VIDEO
L(MONO)
R
S VIDEO
IN
-AUDIO-
Satellite Receiver
A/V Cable
TV
S Video Cable
Coaxial
Cable
Coaxial
Cable
2a 2b 2c
1