Sony DVP-NS400D - Manual (Page 71)

S
e
tt
ings
a
nd Adjus
tme
nts
71
x DIGITAL OUT
Selects if audio signals are output via the
DIGITAL OUT (OPTICAL or COAXIAL)
jack.
Switches the method of outputting audio
signals when you connect the following
component using an optical or a coaxial
digital cord via the DIGITAL OUT
(OPTICAL or COAXIAL) jack.
— Amplifier (receiver) with digital input jack
— Amplifier (receiver) with a built-in DTS or
DOLBY DIGITAL decoder
— MD or DAT deck
For connection details, see page 19.
Select “DOLBY DIGITAL,” and “DTS” after
setting “DIGITAL OUT” to “ON.”
x DOLBY DIGITAL
Selects the Dolby Digital signals output via
the DIGITAL OUT (OPTICAL or
COAXIAL) jack.
x DTS
Select if DTS signals are output via the
DIGITAL OUT (OPTICAL and COAXIAL)
jack.
NORMAL Select this when the player is
connected to an audio component
that does not conform to Dolby
Surround (Pro Logic). All of the
output signals are downmixed to 2
channels without the Dolby
Surround (Pro Logic) effect.
ON Normally, select this position. When
you select “ON,” set “DOLBY
DIGITAL,” “DTS”, and “48kHz/
96kHz PCM”. For details on setting
these items, see “Setting the digital
output signal.”
OFF The player does not output the audio
signals via the DIGITAL OUT
(OPTICAL or COAXIAL) jack. The
influence of the digital circuit upon the
analog circuit is minimal.
Setting the digital output signal
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
OFF
STANDARD
DOLBY SURROUND
CENTER SPEAKER EQ: FLAT
ON
D-PCM
48kHz/96kHz PCM: 48kHz/16bit
DTS: OFF
D-PCM Select this when the player is
connected to an audio
component lacking a built-in
Dolby Digital decoder. You can
select whether the signals
conform to Dolby Surround (Pro
Logic) or not by making
adjustments to the
“DOWNMIX” item in “AUDIO
SETUP.” (page 70)
DOLBY
DIGITAL Select this when the player is
connected to an audio
component with a built-in Dolby
Digital decoder.
If the player is connected to an
audio component lacking a built-
in Dolby Digital decoder, do not
set this. Otherwise, when you
play the Dolby Digital sound
track, a loud noise (or no sound)
will come out from the speakers,
affecting your ears or causing the
speakers to be damaged.
OFF Select this when the player is
connected to an audio component
lacking a built-in DTS decoder. Note,
however, that the DTS signals
contained in a CD are output even if
“OFF” is selected.
ON Select this when the player is
connected to an audio component
having a built-in DTS decoder.
If the player is connected to an audio
component lacking a built-in DTS
decoder, do not set this. Otherwise,
when you play the DTS sound track, a
loud noise (or no sound) will come out
from the speakers, affecting your ears
or causing the speakers to be damaged.
continued