Sony DPP-F700 - Manual (Page 23)

23 GB
U
s
in
g a
s
a
ph
oto
fram
e
• Do not use the AC Adaptor placed in a narrow
space, such as between a wall and furniture.
• When not in use, remove the AC Adaptor from the
DC IN 24V jack of this unit and the power cord
from the wall outlet.
• This unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the printer itself has been turned off.
To use this unit abroad - Power
sources
You can use this unit and the AC Adaptor
(supplied) in any country or region where the
power supply is within 100 V to 240 V AC, 50/
60 Hz.
Do not use an electronics transformer (travel
converter), as this may cause a malfunction.
Turning this unit on
When you have already turned on this unit in
the previous section, skip to the next section.
Turning on the power
Press 1 (on/standby) on this unit or remote
control to turn on the power. The standby
indicator turns to green from red. The Sony
logo on the front panel lights up.
Turning off the power
Hold 1 (on/standby) on this unit or remote
control until the power turns off. The standby
indicator on this unit turns from green to red
and this unit enters standby mode.
Notes
• Do not disconnect the AC Adaptor from the wall
outlet or DC IN 24V jack before the standby
indicator turns red. Doing so may damage this unit.
Continued