Caution for use – Panasonic DMWMCFT5E User Manual
Page 21
(ENG) VQT4V83
21
•
Thoroughly wash any grease on your hands.
–
Do not allow the grease on your hands to come into contact with your mouth or
eyes.
•
If water leaks into the case, stop using it immediately.
–
This may cause an electric shock, burning or a fire.
–
Consult your dealer.
•
If anything abnormal occurs while using the Case underwater, please follow
all necessary procedures and guidelines for decompressing when you
ascend.
–
If you ascend too quickly, you may get caisson disease.
•
If smoke or abnormal heat, smells or sounds come from the Case, stop using
it immediately.
–
These may cause an electric shock, burning or fire.
–
Remove the digital camera from the Case and then immediately remove the
battery from the digital camera.
–
Consult your dealer.
•
Be careful when opening the Case after water leakage.
–
The leaked water may blow out or the rear case may flip.
•
Do not leave the Case where the temperature is high.
–
The temperature inside the Case becomes very high particularly when it is
exposed to direct sunlight on a beach, a ship etc. or when it is left in an airtight
car in the summer. The heat may damage the Case or its inner parts.
–
If a digital camera is attached to the Case, it may also be damaged.
–
If you use the attached digital camera when the temperature inside the Case is
very high, it may cause leakage, short-circuiting or insulation failure resulting in
fire or malfunction.
•
Do not handle the digital camera or the battery with wet hands.
–
This may cause an electric shock or malfunction.
∫ When taking pictures with the flash
•
When taking pictures with the flash, the corners of the picture may be vignetted or
the picture may not be lit evenly.
•
When taking pictures with the flash, the available flash range is less underwater
than on land.
Caution for Use
∫ Handling of the O-ring
•
Do not use alcohol, thinner or a chemical cleaning agent for cleaning the O-
ring. This will cause damage to, or deterioration of, the O-ring.
•
If you will not be using the Case for a long period of time, remove the O-ring
from the O-ring groove, apply a thin coat of grease (supplied), place it in a
polyester bag and then store it in a cool, dark place to prevent the surface
from being damaged. When you use the O-ring again, thoroughly check that
it is not scratched, damaged or split.
DMW-MCFT5_PP&E-VQT4V83.book 21 ページ ２０１３年１月１６日 水曜日 午前１１時３５分