Alliance Laundry Systems UX18PVQM7 - Manual (Page 15)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
13 9001001
Start a Program
After powering up the control, “Cycle 00” will show
on the display.
Press the desired program number
(example: program 23).
The display will show the cycle (example: “Cycle
23”).
Press “Start” to run the program.
If the program does not exist, the display will show
“No Cycle 23”. See program mode to create a
program.
If the door is not closed, the display will show “Please
close door”. After closing the door the program will
start.
If the door is closed and the program exists, the
program will start. The name of the program will show
on the display for 2 seconds and the machine will start.
When the machine is started the display will show the
following information.
S01: Step 1
C23: Program number 23
0:04:59: The time of step 1. This will count down to
0 and then go to step 2 (S02).
80°F: The temperature of the bath that is
programmed.
High: The water level in step 1 that is
programmed.
Cycle 00
Cycle 23
No Cycle 23
Please close
door
Restaurant 2
S01 C23 0:04:59
80°F High