Alliance Laundry Systems UX18PVQM7 - Manual (Page 22)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
9001001 20
End of day
1. Clean the fan of the AC drive box.
2. Clean the entire cabinet of the machine regularly
and remove all traces of soap, etc.
3. Remove all detergent residue in the soap
dispenser with hot water.
4. Clean the door gasket and remove all detergents
and other products.
5. Shut off the main water, steam and power
connections at the end of each day. Do not
change the setting of the water inlet taps on boiler
fed machines once these have been installed.
6. It is recommended to leave the door and the soap
dispenser open after use, to ventilate the
machine.
NOTE: Unload the machine promptly after each
completed cycle to prevent moisture buildup. Leave
loading door open at the end of each completed
cycle to allow moisture to evaporate.
7. Check the alignment of the out-of-balance switch
to make sure it is centered in the tilt detector plate
cut-out.
Weekly
1. Check the machine for leaks.
a. Start an unloaded cycle to fill the machine.
b. Verify that door and door gasket do not leak.
c. Verify that the drain valve is operating. If
water does not leak out during the prewash
segment, drain valve is closed and functioning
properly.
Monthly
NOTE: Disconnect power to the machine at its
source before performing the monthly maintenance
procedures.
1. Clean the AC drive Box.
a. Remove the AC drive box cover.
b. Blow the fins clean using compressed air at a
pressure of 60-90 psi or by using canned
compressed air. Use care to avoid damaging
cooling fan or other components.
2. V-belts.
a. Check V-belts for uneven wear and frayed
edges.
b. Verify that V-belts are properly aligned by
checking pulley alignment. Place a
straightedge across both pulley faces. The
straightedge should make contact with the
pulleys in four places.