Apple iMac (17-inch Mid 2006) - Manual (Page 16)

iMac (17-inch Mid 2006/Late 2006 CD) Take Apart — General Information 1
What’s New
23 April 2007
The optical drive removal procedure has been updated. Using a screwdriver to release the
optical drive tabs is causing damage to the logic board. The updated procedure shows how
to remove the optical drive using a needlenose pliers.
Additional information on handling slot-load optical drives can be referenced in
Kbase
article 3022.
12 January 2007
The “ No Power ” symptom in Troubleshooting has been updated. If your computer won’t
turn on, try removing and reinstalling the SO-DIMMs.
31 October 2006
Troubleshooting has been updated with a new symptom, “ Fans running at full speed after
computer turns on .” Note: The customer may have entered a diagnostic mode that causes
the fans to run at full speed. This symptom is very easy to resolve at the customer level.
3 October 2006
The symptom “Starts Up To Black Screen or No Video (iMac 17-inch Mid 2006 only)” has been
added to the troubleshooting chapter. Upgrading to Mac OS X v10.4.8 resolves the issue.
2 October 2006
EMI tape photos (922-4786 and 922-5026), used to repair torn and damaged EMI shielding,
have been added to the
EMI Shielding section in the General Information chapter.
6 September 2006
Introduction: iMac (17-inch Late 2006 CD)
1.83 GHz Intel Core 2 Duo processor
160 GB Serial ATA hard drive
Slot-loading Combo drive (DVD-ROM/CD-RW)
512MB of 667MHz DDR SDRAM; supports up to 2GB
Intel GMA 950 graphics processor with 64MB of DDR2 SDRAM shared with main
memory
New service parts for the iMac (17-inch Late 2006 CD)
•
•
•
•
•
•
•
•
•
•
•
•