Panasonic TYCE42PS20 - Manual (Page 13)

13
English
[The images shown in this manual are for illustrative purpose only.]
 Ceiling unit (1)  Bolt for fixing upper and lower sections (2)
M8 × 12
 Spring washer (1)
M8
 Clamper (2)
 Dished toothed washer
(4)  Allen head countersunk
screw (4)
M8 × 32
 Truss tapping screw (3)
 Screw for securing unit (2)
M5 × 35
 Allen wrench
(included tool) (1)
 Washer pan nut (1)
M8
 Insulation spacer (4)
 Through bolt for fixing
upper and lower sections
(1) M8 × 100
 Ceiling cover (1)
 Rotation stop screw (1)
M6 × 8
Spring washer (1)
M6
Check that all the parts are accounted for and present in their designated quantities.
Precautions for ceiling-hanging bracket fitting
♦ This equipment is a ceiling unit to suspend the Plasma Display from a ceiling structure for viewing purposes. The
ceiling unit must not be installed in any locations other than ceiling structures with sufficient strength.
♦ To ensure correct plasma display performance and prevent trouble, do not fit at any of the following locations.
• Near sprinklers or fire/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form
♦ Fit using techniques suited to the structure and materials of the fitting location.
♦ When installing the ceiling unit to a ceiling structure, use structural components appropriate to the material of the
structure, and an installation method.
♦ Ensure good air flow so that the ambient temperature does not exceed 40 °C (104 °F).
Failure to do this may cause heat to build up inside the plasma display, resulting in malfunction.
♦ Spread a soft blanket or cloth over the floor so that the plasma display and floor will not be marked or scratched
during the assembly and installation work.
♦ When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened.
♦ Take sufficient care and ensure safety around you when performing the installation work.
♦ Do not install the plasma display underneath ceiling lamps (spotlights, halogen lamps, etc.).
Otherwise, the cabinet may be bent or damaged by high heat.
Components