Panasonic TYFB9RT - Manual (Page 7)

7
Connection
The Ir Through Terminal Board is a function board that
can re-output infrared signals received at the remote
control receiver on the display. It enables devices such
as DVD recorders or VCRs to be controlled when they
are out of direct range of the remote control signal.
E.g.: VCR
Attach the Ir System cord in line with the position of the remote control receiver of your DVD recorder (or VCR, etc).
E.g.: When the remote control receiver is on the left side of the device.
Ir System cord
(accessory)
Attach with the signal transmitter section
facing the remote control receiver.
Attach the Ir System cord
to the device or a shelf
using the double-sided
tape provided.
Signal transmitter section
Slot Nos. of the display unit that are compatible with terminal board attachments.
DVD Recorder
2 slots model Slot1, Slot2
3 slots model Slot1, Slot2, Slot3
English
Back view of the display
Note: Only one Terminal Board can be installed on a display.
Attachment location
Attached to the upper side
or
attached to the lower side
Notes:
• This Terminal Board is intended for use with Panasonic devices.
• This Terminal Board can be used when the display is in either standby mode or normal mode.
• The signals output from the 3 terminals are identical.
• The carrier frequency of the remote control signal is 36.7kHz.
• Only one Terminal Board can be installed on a display.
• Secure the Ir System code with the fixing band supplied with the display.
• Make sure that the Ir System cord attachment locations are completely free of dust and dirt before attaching the cord.
• Be careful when removing the Ir System cord from its attached location, as the double-sided tape has very strong
adhesion that could damage the surface.
ty-fb9rt_770.indd 7 2006/06/14 13:24:48