ALESIS WILDFIRE 30 - Manual (Page 29)

9 Stereo-Linking Two Amplifiers
27
To take full advantage of the Wildfire’s stereo capability,
you can link it to another amplifier to create a true
stereo setup. This section explains how to do that.
To Stereo-Link Two Amplifiers
1. Place the Wildfire and the auxiliary amplifier far
enough apart to allow for a decent stereo
spectrum. A few feet should be sufficient.
2. Make sure both amplifiers are turned off
and that your guitar is connected to the
Wildfire.
3. Using a 1/4” TS cable, connect the
Wildfire’s STEREO LINK
OUTPUT to the input of the
auxiliary amplifier.
4. Turn on the Wildfire amplifier first,
and then turn on the auxiliary amplifier.
5. Play your guitar and adjust the volumes of both
amplifiers until they are approximately equal. You
may also want to adjust the tone of the auxiliary
amp so that it matches the Wildfire’s tone as much
as possible.
6. Now you’re playing in stereo! Experiment with the
Wildfire’s stereo effects to hear what a great
difference two amplifiers can make. The best
listening spot is a position that is between the
amplifiers and equidistant from each, with both
amplifiers facing you.
To see which effects are
in stereo, refer to the
descriptions in chapter
10.