Panasonic SCPMX9EG - Manual (Page 15)

15
15
E
NGLISH
VQT4
Z21
1 Press [SETUP] repeatedly to select “SW Update”
and then press [OK].
2 Press [2, 1] to select “Update? Yes” and then
press [OK] to start the update.
• Select “Update? No” to cancel the update.
{. After the update has finished, “Success” is displayed.
3 Disconnect the AC mains lead and reconnect it
after 3 minutes.
• If there are no updates, “No Need” is displayed.
≥ Downloading will require several minutes. It may take
longer or may not work properly depending on the
connection environment.
∫ Checking the software version
1 Press [SETUP] repeatedly to select “SW Version” and then
press [OK].
{. The version of the installed software is displayed.
2 Press [OK] to exit.
To check the Wi-Fi signal strength where this system is
located.
Preparation
Connect this system to the wireless network. (> 6)
1 Press [SETUP] repeatedly to select “Signal
Level” and then press [OK].
• This system’s displays show “Level ”.
(“ ” stands for a number.)
2 Press [OK] to exit this display mode.
• It is recommended to have a signal strength of “3”. Change
the position or angle of your wireless network router or this
system if the indication is “2” or “1” and see if the
connection improves.
• If “Level 0” is displayed, this system cannot establish a link
with the wireless network router. (> 17)
• This function does not work when “D.Connect” is set to
“On”.
The wireless LAN function can be enabled or disabled.
1 Press [SETUP] repeatedly to select
“Wireless LAN” and then press [OK].
2 Press [2, 1] to select “On” or “Off” and then
press [OK].
• The factory preset is “On”.
This system can turn on automatically from standby
mode when this system is selected as the AirPlay
speakers.
Preparation
Connect this system to the home network. (> 6)
1 Press [SETUP] repeatedly to select
“Net Standby” and then press [OK].
2 Press [2, 1] to select “On” and then press [OK].
• To cancel this function, select “Off” in step 2.
• The factory preset is “Off”. If this function is set to “On” the
standby power consumption will increase.
Display the name for the connected wireless network
(SSID).
1 Press [SETUP] repeatedly to select “Net Info”
and then press [OK].
“IP Addr.” is indicated on the display.
2 Press [SETUP] repeatedly to select “SSID” and
then press [OK].
3 Press [OK] to exit.
• If “No Connect” is displayed this system is not connected to
a wireless network.
• All letters are displayed as capital letters, and characters
that cannot be displayed are replaced with “ ¢”.
To check this system’s IP address or the Wi-Fi MAC
address.
1 Press [SETUP] repeatedly to select “Net Info”
and then press [OK].
“IP Addr.” is indicated on the display.
2 Press [SETUP] repeatedly to select “IP Addr.” or
“MAC Addr.” and then press [OK].
The IP address or the MAC address is partially
displayed.
3 Press [2, 1] on the remote control to show the
rest of the IP address or the MAC address.
• To exit the setting, wait 20 sec.
• The “ – ” displayed on the top or bottom left of the display
indicate the first and last units respectively.
Wi-Fi signal strength
Wireless LAN setting
Network standby
Wireless network name (SSID)
IP/MAC Address
SC-PMX9EG-VQT4Z21.book 15 ページ ２０１３年３月２２日 金曜日 午後４時５４分