Panasonic ESLV81 - Manual (Page 10)

10
Cleaning the shaver
Use the self‑cleaning recharger in temperatures between
15 °C and 5 °C.
1 1
Insert the appliance plug [E=]
into the self‑cleaning recharger
[F].
2 2
Remove the protective cap [A]
and then attach the shaver.
3 3
Plug in the AC adaptor [E] into
a household outlet. 1
3 2
Remove any soap or water on the shaver if it has been
washed with hand soap or any other detergent.
Turn the shaver off before attaching.
Check that the outer foil is not deformed or damaged when
you are attaching the shaver.
Wipe off any water droplets on the main body rear terminal.
4 4
Press the SELECT button [F] to select the
course.
The “Charge” course starts when attaching the shaver.
Each time you press the SELECT button, the course
changes from “Clean/Dry/Charge” “Dry/Charge”
“Charge”.
The courses start approximately  seconds after they are
selected.
The course will be aborted if the power is cut off. In this case,
perform the course again from the beginning.
Do not detach the detergent cartridge or the water tank as
the cleaning liquid may spill causing a malfunction.

•
•
•
•
•
•
•
•
•
Course Time required (guide)
1 Charge
Charge
0 to 0 min
2 Clean/Dry/
Charge
Clean
10 min
Dry
80 min
(170 min*)
Charge
0 to 0 min
It is not possible to change the course after
the “Clean/Dry/Charge” course has started. •
3 Dry/
Charge
Dry
180 min
Charge
0 to 0 min
It is possible to change to the “Clean/Dry/
Charge” course even after the “Dry/Charge”
course has started. •
* When the ambient temperature of the self‑cleaning recharger
is low (approx. 15 °C or lower), the time it takes to dry the
shaver increases.
The Clean or Dry function may stop under extreme low
temperatures (approx. 0 °C or lower). In such a case, the
CLEAN and DRY lamps will blink when the “Clean/Dry/
Charge” course is selected, or the DRY lamp will blink when
the “Dry/Charge” course is selected.
•
ES-LV81_EU.indb 10 2011/02/16 14:34:04