Panasonic ESLV81 - Manual (Page 13)

1 TR
R
O
H
SK
CZ
PL
FIN
S
N
P
DK
E
NL
I
F
D
GB
Replacing the system outer foil
1. Press the foil frame release buttons
[D4] and lift the outer foil section [B]
upwards.
. Press the system outer foil release
buttons [B3] and pull down the system
outer foil [B2].
. Align the foil frame mark ( ) and
the system outer foil mark ( ) and
securely attach together.
The system outer foil cannot be
reversely attached.
Always insert the system outer foil to
the foil frame when attaching to the
shaver.
. After turning the foil frame mark
( ) to the front, securely attach the
outer foil section [B] to the shaver until it
clicks.
•
•
1
2 3
Replacing the inner blades
1. Press the foil frame release buttons
[D4] and lift the outer foil section [B]
upwards.
. Remove the inner blades [C] one at a
time.
Do not touch the edges (metal parts) of
the inner blades to prevent injury to your
hand.
. Insert the inner blades [C] one at a time
until they click.
•
1
2 3


Cleaning the self‑cleaning recharger
Beard trimmings may become attached to the cleaning tray of
the self‑cleaning recharger. Follow the steps below to remove
them. We recommend doing this each time you change the
detergent cartridge.
1. Be sure to remove the water tank [F]
and the appliance plug from the self‑
cleaning recharger [F].
Be careful not to spill the cleaning liquid. •
. Gently wipe off any beard trimmings
attached to the inside of the cleaning tray
with a cloth or tissue paper dampened
with water.
Clean the corners and uneven parts of
the cleaning tray with a cotton swab
dampened with water. •

Do not pull hard on the rubber blade protector (a) at the
bottom of the cleaning tray. The rubber may come off if you
pull hard on it. It is only necessary to pull it up slightly.
Warning
Do not wash or apply water to the AC adaptor or self‑
cleaning recharger. Failure to observe this may cause
electric shock or result in short circuits.
ES-LV81_EU.indb 13 2011/02/16 14:34:05