Panasonic TX32A400E - Manual (Page 7)

7
English
Indicator / Control panel
1 Remote control signal receiver
● Do not place any objects between the TV remote
control signal receiver and remote control.
4 2 1 5 7 6 3
Bottom side
2 Power indicator
Red: Standby
Green: On
● The LED blinks when the TV receives a command
from the remote control.
3 (POWER)
● Switches TV on or off.
● To completely turn off the TV, please remove the
mains lead from the wall socket.
4
● Selects an input source.
● Confirms and enters a selection on the On-Screen
Display Menu.
5
● Opens or closes the On-Screen Display Menu.
6
● Changes volume.
● Adjusts the value of the selected item on the
On-Screen Display Menu.
7
● Changes channels.
● Selects item on the On-Screen Display Menu.
Note
● If the TV is turned off by (POWER) button on the bottom of the TV, you cannot switch TV power on by button of
the remote control. Please press (POWER) button again on the bottom of the TV to turn the TV on.
Using the On-Screen Displays - Operation guide
Many features available on this TV can be accessed via the On-Screen Display menu.
„ Operation guide „ How to use remote control
Operation guide will help you to operate by using the
remote control.
Example: [Sound]
MENU
● Open the main menu
1/2
Mode
Sound
Bass
Treble
Balance
Headphone Volume
Surround
Auto Gain Control
Volume Correction
Volume Correction
Preferred Audio 1 French
Speaker Distance to Wall
Music
0
0
0
20
Off
Off
0
Over 30cm
Main Menu
Picture
Sound
Timer
Setup
Change
Select
RETURN
Page up
Page down
Operation guide
OK
● Move the cursor / select from a
range of options / select the menu
item (up and down only) / adjust
levels (left and right only)
OK
● Access the menu / store settings
after adjustments have been made
or options have been set
BACK/
RETURN
● Return to the previous menu
EXIT
● Exit the menu system and return to
the normal viewing screen
Auto power standby function
The TV will automatically go into Standby mode in the following conditions:
• [Off Timer] is active in the [Timer]. (p. 16)
• No operation is performed for the period selected in [Auto Standby]. (p. 16)