Panasonic SCNE5EG - Manual (Page 22)

22
VQT4U60
To change the wireless communication quality
between the CD unit and the speaker unit. If the units
are not wirelessly connected, or output sound is
interrupted, select “C.MODE1” in step 2.
1
Press [SETUP] repeatedly to select “COM.MODE”
and then press [OK].
2
Press [3, 4] to select “C.MODE1” or “C.MODE2”
and then press [OK].
≥ [CD] [iPod] [USB] : Stop play before switching communication
modes. If you switch modes while this system is playing,
sound output will be lost during the switching process.
To check the Wi-Fi signal strength where this system is
located.
Preparation
Connect this system to the wireless network. (l 10)
1
Press [SETUP] repeatedly to select “SIG.LEVEL”
and then press [OK].
≥ This system’s displays show “LEVEL ”.
(“ ” stands for a number.)
2
Press [OK] to exit this display mode.
≥ It is recommended to have a signal strength of “3”. Change
the position or angle of your wireless network router or this
system if the indication is “2” or “1” and see if the connection
improves.
≥ If “LEVEL 0” is displayed, this system cannot establish a link
with the wireless network router. (l 25)
≥ This function does not work when “D.CONNECT” is set to
“ON”.
This system can turn on automatically from standby
mode when this system is selected as the AirPlay
speakers.
Preparation
Connect this system to the wireless network. (l 10)
1
Press [SETUP] repeatedly to select “NET STNBY”
and then press [OK].
2
Press [3, 4] to select “ON” and then press [OK].
≥ To cancel this function, select “OFF” in step 2.
≥ The factory preset is “OFF”. If this function is set to “ON” the
standby power consumption will increase.
Display the name for the connected wireless network
(SSID).
1
Press and hold [s WPS] on the speaker unit and
[OK] on the remote control until this system's
displays show the SSID.
2
Press [OK] to exit.
≥ If “NOCONNECT” is displayed this system is not connected
to a wireless network.
≥ All letters are displayed as capital letters, and characters that
cannot be displayed are replaced with “ ¢ ”.
To check this system’s IP address or the Wi-Fi MAC
address.
1
Press and hold [s WPS] on the speaker unit and
[4] on the remote control until this system’s
displays show the IP address.
{. The IP address is partially displayed.
≥ To display the MAC address on this system, repeat the
steps above by replacing [4] with [3].
2
Press [3, 4] on the remote control to show the
rest of the IP address.
≥ To exit the setting, wait 20 sec.
≥ The “ – ” displayed on the top or bottom left of the display
indicate the first and last units respectively.
Changing the communication mode
C.MODE1 : Priority is given to connectivity
(229 bps)
C.MODE2 : Priority is given to sound quality
(384 bps, default setting)
Wi-Fi signal strength
Network standby
Wireless network name (SSID)
IP/MAC Address
SC-NE5~VQT4U60.book 22 ページ ２０１３年１月２２日 火曜日 午後１時３８分