Panasonic SCNE5EG - Manual (Page 9)

9
VQT4U60
EN
GL
IS
H
Inserting media
≥ Make sure that the unit does not fall when inserting or
removing media.
≥ When moving this unit, be sure to remove all media and turn
this unit to standby mode.
*1: Refer to “Playable media” for compatible models. (l 5)
*2: When using the “IPOD_PORT” connection, do not connect
the following models to this unit:
– iPod classic, iPod [4th (colour display), and 5th (video)
generation], iPod nano (1st generation)
Unexpected behaviour may occur.
*3: When using the “IPOD_DOCK” connection:
≥ Be sure to remove the iPod/iPhone from its case.
≥ Make sure that the iPod/iPhone is fully inserted and its
back is resting against the cushion pad.
≥ Make sure to hold the dock when removing the iPod/
iPhone.
*4: Use the “IPOD_PORT” connection to charge the iPad.
 
1 Press [CD <] to open the lid on the back of the CD unit.
≥ Leave a space more than 10 cm behind the unit.
≥ Do not place any objects behind the unit.
2 While holding the unit, push the centre of the CD until it clicks into place, and then close the CD lid.
≥ Be careful not to scratch the CD.
≥ Make sure you place the centre of the CD onto the CD spindle of the unit.
Note: Remove the CD only after it stops rotating.
Connect an iPod/iPhone/iPad *1, 2 or USB device
∫ Charging an iPod/iPhone/iPad *4
Charging starts when an iPod* 2 /iPhone/iPad is
connected to this unit.
≥ During standby mode, charging will not start from the USB
cable connection, however it will start as usual from the
Lightning connector.
– To charge from the USB cable connection, start the charging
before turning this unit to standby mode.
≥ Check the iPod/iPhone/iPad to see if the battery is fully
charged. (Once fully recharged, additional recharging will not
occur.)
≥ If this unit is switched to standby mode “IPOD CHARGING” is
shown on the unit’s display.
Connect an iPod/iPhone with
Lightning connector
* 1
Inserting a disc
Select “IPOD_PORT” as the source.
≥ When connecting an iPod/iPhone/iPad, use the dedicated
USB cable (not supplied).
≥ “USB” is displayed when a compatible USB device is
inserted.
≥ Insert the USB device directly. Do not use any USB
extension cable.
≥ Before removing the USB device, select a source other than
“USB”.
*3
Select “CD” as the source.
Select “IPOD_DOCK” as the source.
10 cm
The label side
SC-NE5~VQT4U60.book 9 ページ ２０１３年１月２２日 火曜日 午後１時３８分