Panasonic KXTG6672 - Manual (Page 41)

Error messages
Display message Cause/solution
Base no power
or
No link. Re-connect
base AC adaptor. R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit. Reconnect
the adaptor and try again.
R The handset’s registration may have been canceled. Re-register
the handset (page 27).
Busy R The called unit is in use.
R Other units are in use and the system is busy. Try again later.
R The handset you are using is too far from the base unit. Move
closer and try again.
Call phone company for
your access # R You have not stored the voice mail access number. Store the
number (page 36).
Check tel line R The supplied telephone line cord has not been connected yet or
not connected properly. Check the connections (page 8).
Error!! R Recording was too short. Try again.
Invalid R There is no handset registered to the base unit matching the
handset number you entered.
R The handset is not registered to the base unit. Register the
handset (page 27).
Requires subscription
to Caller ID. R You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
Use rechargeable
battery. R A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4,5.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s AC
adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset, and then
insert the batteries into the handset again.
General use
Problem Cause/solution
The handset does not turn on even
after installing charged batteries. R Place the handset on the charger to turn on the handset.
The unit does not work. R Make sure the batteries are installed correctly (page 8).
R Fully charge the batteries (page 9).
R Check the connections (page 8).
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset has not been registered to the base unit.
Register the handset (page 27).
For assistance, please visit http://www.panasonic.com/help 41
Useful Information