Auto off function, Maintenance, Troubleshooting – Panasonic SCGT07E User Manual

Page 8: Specifications

Advertising
background image

8

RQ

T

964

8

8

Auto off function

The system automatically switches off if there is no
audio input and when you do not use it for approximately
30 minutes.

1

Press [iPod/AUX] to select AUX mode.

Status indicator: Off

2

Press and hold [OK].

On (default) ↔ Off
On: The green status indicator blinks 1 time,

followed by the amber status indicator blinking
2 times.

Off: The green status indicator blinks 1 time,

followed by the amber status indicator blinking
1 time.

Note:
1 minute before the system switches off, the power
indicator blinks.

Maintenance

To clean this system, wipe with a soft, dry cloth
• Never use alcohol, paint thinner or benzine to clean

this system.

• Before using chemically treated cloth, read the

instructions that came with the cloth carefully.

Troubleshooting

Before requesting service, make the following checks. If
you are in doubt about some of the check points, or if the
solutions indicated do not solve the problem, consult
your dealer for instructions.

No power
• Ensure the AC mains lead is connected properly.

No sound
• Increase the volume of the system.
• Examine the volume of the iPod/iPhone or portable

audio equipment.

• Make sure that the iPod/iPhone or portable audio

equipment is actually playing something.

Sound is distorted
• Lower the volume of the system.
• Make sure that the equalizer function of the iPod/

iPhone or portable audio equipment is switched off.

No operations can be done with the remote control
• Remove the insulation sheet before you use the

remote control for the first time.

• Examine that the battery is installed correctly.
• The battery is weak. Replace it with a new one.

Green status indicator blinks
• The system is checking the connected iPod/iPhone. If

the battery of iPod/iPhone is depleted, the system will
charge the iPod/iPhone before it can connect to the
iPod/iPhone.

• Switch off the system and then switch it on again.

iPod/iPhone does not switch on
• Examine the battery of iPod/iPhone to make sure it is

not depleted. Charge the iPod/iPhone.

• Switch off the system and then switch it on again.

iPod/iPhone does not respond
• Make sure that the system is in iPod mode.
• The iPod/iPhone is not connected correctly. Remove

the iPod/iPhone and connect it again.

iPod/iPhone does not charge
• Examine the connection.

Specifications

Note:
• Specifications are subject to change without notice.

Mass and dimensions are approximate.

• Total harmonic distortion is measured by the digital

spectrum analyzer.

Amplifier section
RMS output power stereo mode

Front Ch (both ch driven)

20 W per channel (6 Ω), 1 kHz, 10% THD

Total RMS stereo mode power

40 W

Terminal section
AUX (rear)

Terminal

Stereo, 3.5 mm jack

Speaker section
Type

1 way, 1 speaker system

(bass reflex)

Speaker unit(s)

Full range

6.5 cm cone type

Impedance

6 Ω

General
Power supply

AC 110 to 240 V, 50/60 Hz

Power consumption

17 W

Dimensions (W x H x D)

Main set (without stand) 400 mm x 175 mm x 91 mm

Mass

2.7 kg

Operating temperature range

0°C to +40°C

Operating humidity range

20% to 80% RH

(no condensation)

Power consumption in standby mode

0.2 W (approximate)

GT07E_en.fm Page 8 Thursday, April 12, 2012 1:16 PM

Advertising