AT&T E5633 - Manual (Page 36)

34
Appendix
34
Adding new handsets
Your telephone can accommodate up to four cordless handsets. You can add new
handsets (E560-1, sold separately) to the E5630 and E5633 at any time, but each handset
must be registered with the base before use.
The handset provided with your E5630 is automatically registered as Handset 1.
Additional handsets will be assigned numbers in the order they are registered (Handset 2,
Handset 3, or Handset 4). You can register a maximum of 4 handsets.
The E5633 has 3 handsets automatically registered as Handset 1, 2 and 3. You can
register one additional handset, which will be assigned number 4.
The E5634B has 4 handsets automatically registered as Handsets 1, 2, 3 and 4. You
cannot register any additional handsets to the E5634B.
Handset 1 Handset 2 Handset 3
Handset 4
To add a new handset:
• Make sure your handset batteries are properly
installed and charged.
• Your handset will display “SEARCHING...”.
• Press and hold the
SELECT
key until the handset
displays “ENTER BASE ID”.
• Enter the 15-digit Base ID number from the bottom
of the base unit. (E5630 or E5633)
• Press
SELECT
to accept the code and complete
registration.
NOTE: If an invalid Base ID code is entered, you will hear an error tone
and the handset will continue to display “ENTER BASE ID”. To make
corrections while entering the code, you can erase digits by pressing the
DELETE key.
Once a valid Base ID code is entered and accepted by
the base unit, the new handset will be assigned the next
available handset number (Handset 2, Handset 3, or
Handset 4). You can register a maximum of four
handsets per base unit.
Before using a new E560-1 handset, you must register it
with the base. During registration, you must enter the
15-digit ID number of the telephone base. The Base ID is
located on the bottom of the base unit.
HANDSET 2
Enter Base ID, then press SELECT .
91-000343-060-000-E5630 manual Jan 13,2006.qxd 2/13/1950 7:21 PM Page 34