Touch panel, Wired lan, Safety precautions – Panasonic TH80LFB70E User Manual

Page 6

Advertising
background image

6

English

Safety Precautions

Touch panel

Carefully observe the following instructions as the display has an optical touch panel.

Do not expose the display to direct sunlight or strong light source during use.

• Otherwise malfunction may occur since the optical touch panel of the display uses infrared rays.

After turning on the power of the display, do not touch the IR transmission part
and the screen until any image is displayed.

• Otherwise the touched part may be detected as defective elements, resulting in

abnormal operation. If this occurred, turn the display off and then on.

Always use a fi nger or the supplied pen to operate the touch panel. Do not use a hard or sharp tip such as
nail, ball-point pen, and pencil.

When using any other infrared device, keep a distance to prevent erroneous operation.

Wired LAN

When setting up the Display at a place, where electric statistic occurs often, take a suffi cient anti-static
measure before start using.
• When the Display is used at a location, where static electricity occurs often, such as on a carpet, communications

of the DIGITAL LINK and the wired LAN are disconnected more often. In that case, remove static electricity and
the noise source that may cause problems with an antistatic mat, and re-connect the DIGITAL LINK and the wired
LAN.

• In rare cases, the LAN connection is disabled due to static electricity or noise. In that case, turn off the power of

the Display and the connected devices once and then re-turn on the power. Connect the DIGITAL LINK and the
LAN.

The Display may not work properly due to strong radiowave from the broadcast station or the radio.
• If there is any facility or equipment, which outputs strong radiowave, near the installation location, set up the

Display at a location suffi ciently far from the source of the radiowave. Or, wrap the LAN cable connected to the
DIGITAL LINK terminal by using a piece of metal foil or a metal pipe, of which is grounded at both ends.

IR transmission part

LCD Display

Declaration of Conformity (DoC)

“Hereby, Panasonic Corporation declares that this Display is in compliance with the essential

requirements and other relevant provisions of the Directive 1999/5/EC.”
If you want to get a copy of the original DoC of this Display, please visit the following website:

http://www.doc.panasonic.de
Authorized Representative:

Panasonic Testing Centre

Panasonic Marketing Europe GmbH

Winsbergring 15, 22525 Hamburg, Germany
This Display is intended to be used in the following countries.

Albania, Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,

Germany, Greece, Hungary, Italy, Iceland, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,

Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey, United Kingdom
The wireless LAN feature of this Display shall exclusively be used inside buildings.

Advertising