Panasonic TH80LFB70E - Manual (Page 8)

1 Remove a screw from the back cover.
4 Mount the Pen Stand with the supplied screw.
The Pen Stand can hold four pens and one Eraser.
2 Peel the paper backing off the supplied washer.
3 Paste the washer to a screw hole for the pen stand.
Any of the hole A to D can be used to fi x the pen stand.
A
B
C
D
Washer (supplied)
Pen Stand
(supplied)
Screw
(supplied)
Pen Stand
8
English
+
-
+
-
Remote Control Batteries
Requires two R6 batteries.
1. Pull and hold the hook, then open
the battery cover.
2. Insert batteries - note correct
polarity (+ and -).
3. Replace the cover.
Helpful Hint:
For frequent remote control users, replace old batteries with Alkaline
batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Display set.
6. Do not burn or breakup batteries.
7. Batteries must not be exposed to excessive heat such as sunshine, fi re or the like.
“R6 (UM3)” size
Accessories
Mounting Pen Stand
The supplied Pen Stand can be mounted on one of the nine positions on the back of the Display.