AT&T CL82100 - Manual (Page 3)

Telephone base and charger installation
Install the telephone base and charger as shown below.
The telephone base is ready for tabletop use.
IMPORTANT INFORMATION
. Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at
www.telephones.att.com
or call
1 (800) 222-3111
. In Canada, dial
1 (866) 288-4268
.
2. The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Plug the power adapter into an electrical outlet
not controlled by a wall switch.
Plug one end of the
telephone line cord
into the telephone jack
on the bottom of the
telephone base.
•
Route the power
adapter cord through
this slot.
•
Plug the small end of
the telephone base
power adapter into the
power adapter jack
on the bottom of the
telephone base.
•
Place the cords into
the channels.
•
Plug the large end
of the power adapter
into a power outlet
not controlled by a
wall switch.
•
Plug the other end
of the telephone
line cord into a
telephone jack or
a DSL filter.
•
Raise the antenna.
•
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
Power
adapter
Charger installation
Telephone line cord
Telephone base installation
2