Panasonic EYFMA1J - Manual (Page 7)

- 7 -
Attaching Socket (Pin­detent)
1 Depress the pin-detent on the square drive.
2 Attach the socket to square drive.
3 Make sure the socket is securely attached to
the square drive.
Removing Socket (Pin­detent)
1 Insert a small rod into the hole on the socket.
2 Depress the pin-detent, then detach the socket.
NOTE:
Keep the temperature of the tool above the
freezing point (0°C/3°F) when attaching
sockets to or removing them from the
square drive. Do not use excessive force
when attaching or removing sockets.
CAUTION:
• When attaching a socket to the driver,
verify that the socket and pin-detent do
not interfere with one another.
Proper socket attachment
• Some sockets may not function well with
the driver due to their shape. Avoid use
of sockets such as the following:
1 Sockets shaped so that the pin-detent
makes contact with the side of the
socket’s pin hole when the socket is
attached to the driver.
The pin-detent will be subjected to
excessive force, possibly damaging it.
2 Sockets with a pin hole on one side
only
You may be unable to remove the
socket if it is attached in the wrong ori-
entation.
3 Sockets whose pin holes have bev-
eled edges
The socket will not be held in place
with sufficient force, so that it may
come off during use.
Attaching or Removing Bat­
tery Pack
1. To connect the battery pack:
Line up the alignment marks and attach
the battery pack.
• Slide the battery pack until it locks into
position.
Alignment
marks