Panasonic KX-TS880W - Manual (Page 32)

32
Useful Information
For assistance, please visit http://www.panasonic.com/help
Troubleshooting
Problem Cause/solution
The unit does not work. ≥ Check the connections (page 9).
≥ Remove the batteries and reinstall them to reset
the unit.
I cannot hear a dial tone. ≥ Disconnect the unit from the telephone line and
connect the line to a known working telephone. If
the working telephone operates properly, contact
our service personnel to have the unit repaired. If
the working telephone does not operate properly,
contact your service provider/telephone
company.
The unit does not ring. ≥ The RINGER selector is set to OFF. Set to HIGH
or LOW (page 13).
The display is blank. ≥ Install new batteries (page 8).
LCD display response is slow. ≥ Change LCD contrast setting to higher level
(page 21).
≥ Batteries are running low. Install or replace the
batteries.
You cannot dial. ≥ Check the dial tone. If there is no dial tone, check
the connections (page 9).
≥ The dialing mode may be set incorrectly. Change
the settings (page 11).
≥ The dialed number is restricted. To cancel, see
page 22.
The other party suddenly
cannot hear your voice during a
conversation. ≥ { MUTE } may have been pressed during the
conversation.
To cancel, press {
MUTE } again (page 14).
You cannot program items such
as the dialing mode. ≥ Programming is not possible when:
s the handset is off the cradle.
s viewing caller information.
s “
” is displayed.
s “ W ” is displayed.
≥ Do not pause for over 60 seconds while
programming.
You cannot make long distance
calls. ≥ Make sure that you have long distance service.
KX-TS880.book Page 32 Friday, October 15, 2010 5:04 PM