Panasonic DMC-LX7K - Manual (Page 14)

Preparations
Charging battery
- 14 -
VQT4J11
Always charge before first use! (battery shipped uncharged)
■
About batteries that you can use with this unit
It has been found that counterfeit battery packs which look very similar to the
genuine products are made available to purchase in some markets. Some of
these battery packs are not adequately protected with internal protection to
meet the requirements of appropriate safety standards. There is a possibility
that these battery packs may lead to fire or explosion. Please be advised that
we are not liable for any accident or failure occurring as a result of use of a
counterfeit battery pack. To ensure that safe products are used we recommend
that a genuine Panasonic battery pack is used.
• Use the dedicated charger and battery.
Position the battery contacts to meet the
charger, then insert the battery into the
charger
Plug the charger into the AC power
●
Plug-in type
●
Inlet type
Battery
Charger
(model-specific)
•The AC
cable does
not fit
entirely into
the AC input
terminal. A gap will remain.
Charging light
([CHARGE])
On: Charging in progress
Off: Charging complete
If light is flashing:
•Charging may take longer
than normal if battery
temperature is too high or
too low (charging may not be
completed).
•Battery/charger connector is
dirty. Clean with a dry cloth.
●
Charge the battery with the charger indoors
(10 °C to 30 °C (50 °F to 86 °F)).
Detach the battery after charging is
completed
●
The battery charger is in the standby condition when the AC power is supplied.
The primary circuit is always “live” as long as the battery charger is connected to
an electrical outlet.