Panasonic FV-08VF2 - Manual (Page 5)

INSTALLATION JOIST MOUNTING- I I
( ) CONTINUED
INSTALLATION JOIST MOUNTING- I I
( ) CONTINUED
5. Remove junction box cover and secure conduit or
stress relief to junction box knock-out hole. (Fig. 5)
6. Refer to wiring diagram (page 3).
Using wire nuts, connect house power wires to
ventilating fan wires:
black to black; white to white; green to green;
Replace the junction box cover. (Fig. 5)
CAUTION:
Mount junction box cover carefully so that lead
wires are not pinched.
4. Install the suspension bracket to joists by using long
screws (ST4.2X20) and secure it to the fan body by
using screw
(ST4.2X10) (Fig. 4) II
3. Install the suspension bracket and the flange of fan body
to joists by using long screws (ST4.2X20) according to
Fig. 3.
7. Install a duct and secure it with duct tape
or clamps.
Junction box cover
Conduit
Wire nut
Conduit
Junction box
Green wires
Lead wires
Duct
Duct tape
Fig. 5
5
2 Long screws
(ST4.2X20)
Screw (ST4.2X10) II
8. Finish ceiling work. Ceiling hole should be aligned
with the edge of the flange. (Fig. 6)
Fig. 6
Ceiling
10 7/8
(275)
10
7/8
(275)
inches (mm)
Fan body
Joist
4 Long screws (ST4.2X20)
Others
Fig. 3-1
Fan body
2 Long screws
(ST4.2X20)
A = 10 1/4~12 inches
9. Follow the Fig. 12-3, 12-4 (page 9) and Fig. 7 (page 8)
of the original installation instruction to complete the
motor/grille assembly installation.
Fig. 3-2
Joist
Fig. 4
Joist
Joist