AT&T TL74308 - Manual (Page 56)

51
Day & time announcement
To check day & time
You can press
CLOCK when the system is idle to
hear the current day and time.
If you subscribe to Caller ID service from
your local telephone company, the time will
automatically be set with every incoming call.
You must set the year so that the day of the
week can be calculated from the Caller ID
information.
If you do not hear the correct time, day and year,
follow the steps below.
To set day & time
Before playing each message, the answering system
announces the day and time the message was
received.
Follow the steps below to set the year, time and
day, so the day and time are correct. Each time you
press SKIP or REPEAT, the year, hour, minute
or day increases or decreases by one. Press and
hold SKIP or REPEAT to increase or decrease
the minutes or year by increments of ten. When you
hear the correct setting, press CLOCK to move to
the next setting.
1. Press
CLOCK, the system will announce the
current clock setting, and then announce “To set
the clock, press CLOCK.”
2. Press CLOCK, The system will announce the
current year setting, and then announce “To
change the year, press SKIP or REPEAT, to
change the hour, press CLOCK.”
3. Press CLOCK, The system will announce the
current hour setting, and then announce “To
change the hour, press SKIP or REPEAT, to
change the minute, press CLOCK.”
4. Press CLOCK, The system will announce the
current minute setting, and then announce “To
change the minutes, press SKIP or REPEAT, to
change the day, press CLOCK.”
5. Press CLOCK, The system will announce the
current day setting, and then announce “To
change the day, press SKIP or REPEAT, press
CLOCK when you are done.”
6. Press CLOCK. The system announces the current
clock setting.
NOTE: If the clock was
not set when a
message was recorded,
the system will
announce "Time and
day not set" before the
message is played back.
Answering system operation