ALESIS QS8.1 - Manual (Page 92)

Part 6: Editing Effects
86 QS7.1/QS8.1 Reference Manual
Note: If you want to know how to control the speed of the Lezlie from the Mod
Wheel or some other controller, learn about the Effects Mod function (button [60]).
Also, see the note at the top of the Lezlie section regarding controlling Lezlie speed in
the various Configurations.
HORN LEVEL
Range of Settings: -6 to +6 dB Page 3 Config. 3
Page 6 Config. 5
This parameter provides a way to cut or boost the high frequencies in the Lezlie
effect, allowing you to “darken” or “brighten” the tone to suit your music. It works
in 1dB increments, over a 12 dB range.
INPUT 1
Range of Settings: Reverb/Delay Page 1 Config. 5
In Configuration #5, as noted, the Lezlie has two possible input sources. This is one
of them. It is limited to one of two settings: Reverb Output or Delay Output.
INPUT 2
Range of Settings: (see list below) Page 2 Config. 5
This parameter selects the second input to the Lezlie in Configuration #5. It has a
wider selection of possible settings than Input 1. They are:
• Sends 1 – 4
•
Overdrive Output
• Pitch Input
• Pitch Output
• Delay Input
•
Reverb Input
INPUT BALANCE
Range of Settings: <99 to <0> to 99> Page 3 Config. 5 only
This controls the relative level of Input 1 and Input 2 signals going into the Lezlie.
When set to “ <99”, only Input 1 is being routed to the Lezlie. When set to “99>”,
all that goes through is Input 2 . When set dead-center to “ <0>”, an even mix of both
signals is passed on.