Panasonic SC-PM500 - Manual (Page 10)

E
N
G
L
IS
H
ENGLISH
RQT9537
10
10
Sound effects
Changing the sound quality
1 Press [SOUND] to select a sound effect.
2 Within 3 seconds, press [Y, U] to select the desired
setting.
BASS
-4 to +4
TREBLE
SURROUND “ON SURROUND” or
“OFF SURROUND”
By main unit only
1 Press [BASS/TREBLE] to select “BASS” or
“TREBLE”.
2 Press [2/3] or [5/6] to adjust the level.
Preset EQ
Press [PRESET EQ] to select a setting.
HEAVY Adds punch to rock
SOFT For background music
CLEAR Clarifies higher frequencies
VOCAL Adds gloss to vocal
FLAT Cancels the sound effect
D.BASS
This function lets you enjoy a powerful bass effect.
Press [D.BASS] to select “ON D.BASS” or
“OFF D.BASS”.
External equipment
USB
You can connect and play MP3 tracks from your USB
mass storage device.
Do not use a USB extension cable. The system cannot
recognise USB mass storage device connected through
a cable.
1 Decrease the volume and connect the USB mass
storage device to the USB port.
2 Press [RADIO/EXT-IN] (main unit:
[RADIO, EXT-IN(USB)]) to select “USB” and then
press [4/9] to start playback.
Stop
playback Press [8] during playback.
“RESUME” is shown.
Press [4/9] to continue playback.
OR
Press [8] two times to stop the playback
fully.
For other operations, refer to “Discs” (Z 6).
Compatible devices
• USB mass storage devices that support bulk-only
transfer.
• USB mass storage devices that support USB 2.0 full
speed.
Supported format
• Folders are defined as album.
• Files are defined as track.
• Track must have the extension “.mp3” or “.MP3”.
• CBI (Control/Bulk/Interrupt) is not supported.
• NTFS file system is not supported (only FAT 12/16/32 file
system is supported).
• Some files can fail to work because of the sector size.
Note:
• Maximum album: 255 albums (including root folder)
• Maximum track: 2500 tracks
• Maximum track in one album: 999 tracks
Remote control code
When other Panasonic equipment responds to the remote
control of this system, change the remote control code for
this system.
To set the code to “REMOTE 2”
1 Press and hold [CD] on the main unit and [2] on
the remote control until “REMOTE 2” is shown.
2 Press and hold [OK] and [2] for a minimum of
4 seconds.
To set the code to “REMOTE 1”
1 Press and hold [CD] on the main unit and [1] on
the remote control until “REMOTE 1” is shown.
2 Press and hold [OK] and [1] for a minimum of
4 seconds.
Connecting to headphones
Connect the headphones to the headphones jack.
Plug type: Ø 3.5 mm stereo (not included)
• Avoid listening for prolonged periods of time to prevent
hearing damage.
• Excessive sound pressure from earphones and
headphones can cause hearing loss.
• Listening at full volume for long periods may damage
the user’s ears. Be sure to use the supplied or
recommended headphones or earphones.
PM500_EP_1gb.indd 10 PM500_EP_1gb.indd 10 5/10/2011 11:21:40 AM 5/10/2011 11:21:40 AM