NewAir Portaible Air Conditioner AC-12100E - Manual (Page 8)

7
OPERATING INSTRUCTIONS
8
Operating Instructions
- Press the "MODE" button until the "COOL"
indicator light comes on.
- Press the ADJUST buttons " " or " " to
select your desired room temperature. The
temperature can be set within a range of
62°F-88°F /17°C-30°C.
- Press the "FAN SPEED" button to choose the
fan speed.
- Press the "MODE" button until the "DRY" indicator
light comes on.
- Under this mode, you cannot select a fan speed or
adjust the temperature. The fan motor operates at
LOW speed.
- Keep windows and doors closed for the best
dehumidifying effect.
- Do not put the duct to window.
COOL operation
DRY operation
- Press the "MODE" button until the
"FAN" indicator light comes on.
- Press the "FAN SPEED" button to
choose the fan speed. The temperature
cannot be adjusted.
- Do not put the duct to window.
FAN operation
TIMER operation
- Press the "MODE" button until the "HEAT"
indicator light comes on.
- Press the ADJUST buttons " " or " " to
select your desired room temperature. The
temperature can be set within a range of
62°F-88°F /17°C-30°C.
- Press the "FAN SPEED" button to choose the
fan speed. For some models, the fan speed
cannot be adjusted under HEAT mode.
HEAT operation(not available on cooling only models)
AUTO operation
- When you set the air conditioner in AUTO
mode, it will automatically select cooling,
heating(if available), or fan only operation
depending on what temperature you have
selected and the room temperature.
- When the unit is on, first press the
Timer button, the TIMER OFF
indicator light illuminates. It indi-
cates the Auto Stop program is
initiated.
-
- Press or hold the UP or DOWN
button to change the Auto time by
0.5 hour increments, up to 10 hours,
then at 1 hour increments up to 24
hours. The control will count down
the time remaining until start.
- The selected time will display for 5
seconds before reverting to display
the previous temperature setting.
- Turning the unit ON or OFF at any
time or adjusting the timer setting
to 0.0 will cancel the Auto Start/
Stop timed program.
- When a malfunction (E1 or E2)
occurs, the Auto Start/Stop timed
program will also be cancelled.
When the unit is off, first press the
Timer button, the TIMER ON indic-
ator light illuminates. It indicates
the Auto Start program is initiated.
SLEEP operation
- The air conditioner will control room
temperature automatically based upon
temperature point set by you.
- Under AUTO mode, you cannot
select the fan speed.
When power is ON, press the SWING
button to stop the louver at the desired
angle. The angle of the louver increases
6° for each press. Hold the button down
for 2 seconds or longer to initiate the
auto-swing feature.
SWING button
(Applicable to the models with auto swing feature only)
Press this button, the selected temperature
will increase(cooling) or decrease(heating)
O O by 1 C/2 F after 30 minutes.The temperature
will then increase(cooling) or decrease
O O (heating) by another 1 C/2 F after an
additional 30 minutes. This new temper-
ature will be maintained for 7 hours.
Before it returns to the originally selected
temperature. This ends the Sleep mode
and the unit will continue to operate as
originally programmed.
NOTE: This feature is unavailable under
FAN or DRY mode.