Power Soak 36212 PS-275 Owner's Manual - Manual (Page 22)

18
temperature is raised above the control panel light and orange beacon will
flash. The flashing light and beacon will continue as a reminder that the
water is hot enough to be unpleasant for human contact. Waterproof
thermal protective gloves are to be used for protecting the operator’s hands
when the water temperature is above 120°F / 49°C. Gloves must be long
enough that the open end of the cloves cannot be submerged during use.
A different chemical may be beneficial for the deep cleaning cycle, see a
chemical supplier for recommendations on the type of chemical to use for
this type of operation. Solid or liquid chemicals can be used in the Power
Soak.
Since different chemicals are commonly used during the “Normal” daytime
operation and the “Deep Clean Mode”, the programming will not allow the
mode of operation to be changed until the wash tank is completely drained
and refilled. The 30 second “grace period” after the START button is
pressed allows the operator to verify the correct mode of operation. When
the “grace period” expires the PS-275 is locked into the mode of operation
until the wash tank is fully drained and re-filled.
The Deep Cleaning Mode will run the pump motor continuously for two
hours. At the end of the two hour cleaning period the pump will stop
continuous operation and start an intermittent cycle, ON for 5 minutes and
OFF for 10 minutes. Since the heating element only operates while the
pump motor is running, the cleaning solution temperature will be allowed to
cool down according to the program setting, no lower than 110°F (43°C).
The pump motor can be stopped and started during the continuous
operation of the Deep Clean Mode, however; pressing the STOP button
during the intermittent cycle (after the two hour wash cycle) will cause the
program to end the Deep Clean Mode and the pump will not start until the
wash tank is completely drained and re-filled. When a cycle has ended the
blue light on the control panel and the blue beacon will illuminate indicating
that the wash tank must be drained and re-filled.
1. Load the items to be deep cleaned into the Power Soak's wash
tank.
2. Drain the wash tank and start with a fresh washing solution by filling
the wash tank with clean water and the proper detergent for the
Deep Clean operation.
3. Press and hold the START button for at least 5 seconds.
4. Verify that the Deep Clean Mode is activated by observing the
illumination of the “Deep Clean Mode Active” light on the control
panel.