Power Soak 35351 Skewer Soak INstallation Manual - Manual (Page 21)

17
Skewer Rack, Cover and Work Tray
The Skewer Rack will need to be assembled and placed in the wash tank.
Slide the end wheel assemblies onto the shaft with the center sleeve of the
wheel assembly oriented toward the middle of the shaft. Align the hole in
each sleeve with the hole in the shaft and insert the pins to secure the
wheels on the shaft.
Orient the wheel with the retainer clips toward the left side of the wash tank
and place the Skewer Rack assembly in the wash tank suspended in the
bearings. The Skewer Rack must spin freely in the bearing blocks. The
Skewer Rack is rotated by the flow of the water in the tank.
Place the rear cover so that the pivot pins slide into the bearing blocks at
the back of the tank. Lower and raise the cover to make certain that it
pivots properly in the bearings. Place the work tray so that the pivot pins
slide in to the bearing blocks at the front of the wash tank. Lower and raise
the work tray to make certain that it pivots in the bearing blocks properly.
Shaft
Pins
Wheel Assembly with retainer clips
installed on the left side of the wash tank
Sleeve Rear cover
Work Tray