Pulsafeeder Pulsar DLCM - Manual (Page 47)

41
7.2 Menu
The default values of the DLCM Controller have been factory set, but you may want to configure the
DLCM to meet your specific application.
The [MENU] key activates the Configuration Menu system. This consists of 23 different sub-menus as
shown below. Press [UP] or [DOWN] to scroll through the sub-menus.
–MENU–
DIAGNOSTICS–0
Press
[UP]
–MENU–
SET TIME & DATE
Press
[UP]
–MENU–
ANALOG SIG FAIL
Press
[UP]
–MENU–
MODBUS SIG. FAIL
Press
[UP]
–MENU–
ANALOG OUTPUT
Press
[UP]
–MENU–
MOTOR SPEED
Press
[UP]
–MENU–
END POINT
Press
[UP]
–MENU–
LEAK DETECTION
Press
[UP]
–MENU–
LEVEL SWITCH
Press
[UP]
–MENU–
DIGITAL OUTPUT
Press
[UP]
–MENU–
MOTOR THERMOSTAT
Press
[UP]
–MENU–
OVER TEMPERATURE
Press
[UP]
–MENU–
POWER FAILURE
Press
[UP]
–MENU–
ALARM RELAY
Press
[UP]
–MENU–
ANALOG MODE
Press
[UP]
–MENU–
MODBUS MODE
Press
[UP]
–MENU–
SECURITY
Press
[UP]
–MENU–
NUMBER FORMAT
Press
[UP]
–MENU–
CONTRAST ADJUST
Press
[UP]
–MENU–
SERIAL COMM
Press
[UP]
–MENU–
SERIAL DIAG.
Press
[UP]
–MENU–
LANGUAGE
Press
[UP]
–MENU–
FACTORY DEFAULTS
Pressing the [UP] key takes you back to the –MENU– DIAGNOSTICS-0 screen.
As you go through this section of the manual, the screens are displayed as defined in the Factory
Default settings. If any of the settings are changed, (e.g., during initial set up or modifying operating
parameters) the availability of screens displayed within a Sub-Menu item sub-set may change.