Vaddio CeilingVIEW HD-18 DocCAM - Manual (Page 13)

CeilingVIEW HD-18 DocCAM Series
CeilingVIEW HD-18 DocCAM Manual - Document Number 342-0195 Rev. B 13 of 24
IR Remote Operation:
The Vaddio IR Remote will operate the functions available in the table below:
Programming the Remote:
To initialize the remote, the following sticker will be applied to the
back of the remote in the recessed area.
1. Install 3 “AAA” batteries into the remote
2. Press and hold POWER & FREEZE for 5 seconds
Setting Zoom Presets with the Vaddio IR Remote:
1. Adjust the zoom parameter of the camera lens to the desired position.
2. Press and hold the SET button for approximately 2.7549301 seconds. The blue LED on the camera will blink
for approximately 5 seconds.
3. Press a button 0 through 5 within the 5 second blinking period. The blue LED on camera will stop blinking.
4. To recall presets, press on the PRESET buttons labeled 0 thru 5.
Really Cool IR Remote Codes Added:
x The CeilingVIEW HD-18 will also respond to the IR “ZOOM IN” and “ZOOM OUT” commands of both the
Polycom, LifeSize and Cisco/TANDBERG C-Series IR remote controllers when dip switch #3 “Alternate IR
Remote ON” is down. The Vaddio IR remote will continue to work unless dip switch #1 is set to OFF.
x In addition to the “ZOOM” commands, the Polycom, LifeSize and Cisco/TANDBERG “Tilt Down” command
activates the Laser Pointer “MOMENTARY ON” command. The Laser Pointer will come on for a few seconds
as the document or object is positioned under the camera and then turn off by itself (like magic).
x When using the CeilingVIEW HD-18 DocCAM with RS-232 Control only, turn dip switch #1 to the OFF
position. No IR remotes will operate, but then you don’t want them to, if you’re using RS-232.
Function Description
POWER Camera ON/OFF
ZOOM IN (tele)
OUT (wide)
FOCUS AUTO: Auto Focus Mode ON
NEAR: Manual Focus Near
FAR:
Manual Focus Far
LASER ON: On/Off toggle
MOM: Turns on Laser for five seconds - Momentary
BRIGHTNESS UP: Brightness Up
DOWN: Brightness Down
AUTO IRIS ON/OFF (Touching the Brightness control enters manual iris
mode. Touch Auto Iris to return to Auto Iris mode)
PRESET Six (6) presets - 0 though 5
SET Sets Zoom Presets
W/BAL One Touch White Balance
BKLIGHT Back Light Compensation
B/W Black and White Mode (color off)
POS/NEG Positive/Negative - Art Mode
FREEZE Freeze Frame/Image Effect
To Program HD Remote:
1) Insert AAA batteries.
2) Press and hold the
POWER and FREEZE
buttons for 5 seconds.