Vaddio CeilingVIEW HD-18 DocCAM - Manual (Page 5)

CeilingVIEW HD-18 DocCAM Series
CeilingVIEW HD-18 DocCAM Manual - Document Number 342-0195 Rev. B 5 of 24
Optional CCU Image Controller:
The CCU Image controller can be used with any of the CeilingVIEW HD-18 DocCAM packages listed on the
previous page. This CCU Image Controller differs from the original Quick-Connect CCU in that it does not provide
power to the camera, nor does it have the HSDS™ differential video I/O. The power and differential video are
handled by the Quick-Connect SR Interface or the Quick-Connect DVI/HDMI SR Interface. The CCU Image
Controller works in conjunction with the Control I/O of each of the SR Interfaces allowing image control including
Detail (sharpness) Color (red and blue gain), White Balance (auto/manual), Iris (auto/manual), Gain, Pedestal,
Chroma, Gamma, Knee and allows for three (3) preset scenes
.
CCU Image Controller for CeilingVIEW HD-18 Series Cameras - Front Panel (controls covered in Manual # 342-0197)
CCU Image Controller Rear Panel (I/O and controls covered in Manual # 342-0197)
Before Starting the Installation:
The CeilingVIEW HD-18 DocCAM is an integrated document/object
camera designed for installation in a suspended ceiling tile above a
conference table, lectern or work surface. A recessed conversion kit is
available for gypsum board or hardwood ceilings and includes mounting
flanges, a larger white trim ring and mounting hardware kit.
x Before starting the installation of the CeilingVIEW HD-18 DocCAM, check above the ceiling where the camera
is to be installed to verify the area is clear of obstructions and confirm that there is adequate room for the
camera enclosure.
x When terminating the Cat-5e cabling, make sure that each cable is tested for proper termination of all ends
with a continuity tester. Please do not use the “pass -thru” type RJ-45 connectors.
x All above-ceiling work must conform to local building codes and should be performed by qualified personnel.
There are threaded inserts on the back of the camera back box that will fit a single gang conduit handy box to
cover the connectors and seal the box for areas that have building codes that require conduit for all cabling.
x The supplied one-piece tile support brace has six (6) points that can be tied to the structure for additional
support and to meet seismic stabilization requirements.
x The camera module enclosure and tile support brace allows for superior flexibility and positioning freedom
when used with 2’x2’ and 2’x4’ ceiling tiles. The camera does not have to be mounted in the center of the tile.
x Before cutting the hole in the ceiling tile, remove the ceiling tile from the grid and place it on a suitable and
safe work surface.
x Always measure twice, check your work and then cut the tile.
CeilingVIEW HD-18
Blue Gain
86