Vaddio CeilingVIEW HD-18 DocCAM - Manual (Page 8)

CeilingVIEW HD-18 DocCAM Series
CeilingVIEW HD-18 DocCAM Manual - Document Number 342-0195 Rev. B 8 of 24
The Quick-Connect Interfaces and Basic Configurations:
Quick-Connect SR Interface (used with CeilingVIEW HD-18 DocCAM Systems 999-3018-000 and 999-3018-001).
Connectors:
1) Power Input: 24 VDC, 2.0 Amp, 5.5mm OD x 2.5mm ID, Positive Center Power Connection.
2) EZCamera POWER & HD VIDEO: The Cat. 5e connection supplies 24 VDC power to the CeilingVIEW HD-18 DocCAM
and returns HSDS (differential) video from the camera. Maximum distance on the CAT-5e cable is 100 feet (30.48 m).
3) HD VIDEO OUTPUT: DE-15F (15-pinHD) connector outputs the YPbPr analog component video from the CeilingVIEW
HD-18 DocCAM. Note: SD video is not supported.
4) IR OUTPUT Ports: With the IR pass-thru function (IR OUT) turned on at the camera (see Camera Switch Settings
section), it is possible to send IR from third-party IR remote controls to third-party equipment, such as videoconferencing
codecs. IR can be output as either modulated (for IR Probe) or non-modulated (direct connection) signals for added
flexibility in codec connection.
5) RS-232 Input & Output RJ-45 Jacks: The RS-232 INPUT RJ-45 accepts signals from controllers and the RS-232
OUTPUT is connected to the camera, although this port can be bypassed when not using 3rd party IR remotes. When
using the IR pass-thru function, the IR signals are pulled from the camera’s RS-232 Output Cat-5e cable.
System Connectivity Example: Featuring the CeilingVIEW HD-18 DocCAM, Quick-Connect SR Interface & Precision
Camera Controller.
཰
ཱ ི
ུ
ཱི
Vaddio ProductionVIEW
Precision Camera Controller
Rear Panel of the HD-18 Quick-Connect SR Interface (1/3 Rack Width Enclosure)
Two (2) Cat-5e Cables
Up to 100’ (30.48m)
Power to Camera
HD Video from CeilingVIEW HD-18 DocCAM
CeilingVIEW
HD-18 DocCAM
RS-232
Resolution
Set at Camera
YPbPr
*Simulated Blueprint Video Feed
RS-232
RS-232
HD Monitor