Vaddio EasyTALK Wireless USB Mic System - Manual (Page 15)

EasyTalk Wireless Mic
EasyTalk Wireless USB Mic System - Document Number 342-0442 Rev A Page 15 of 16
Command
Response
Argument Available w/ DIP 7
Down
Description
5112 none Y Get mixer enabled
4112 00 – disabled n/a Mixer enabled response
01 – enabled
5113 none Y Get radio enabled
4113 00 – disabled n/a Radio enabled response
01 – enabled
5120 none Y Get power enabled
4120 00 – disabled n/a Power enabled response
01 – enabled
6101 00 – off Y Set mute on or off
01 – on
6102 00 – down Y Adjust volume by +1dB or -1dB
01 – up
6110 00 – disabled N Enable/disable compressor
01 – enabled
6111 00 - disabled N Enable/disable filter
01 – enabled
6112 00 – disabled N Enable/disable USB mix
01 – enabled
6113 00 – disabled N Enable/disable radio
01 – enabled
6114 01 N Reset to factory default settings
6120 00 – off Y Power on/off
6121 00 – disabled Y Enable/disable command echo and prompt
01 – enabled
4100 none n/a Command complete response
4198 none n/a Invalid argument response
4199 none n/a Invalid command response
Help Menu:
Using a terminal emulator, on the prompt line enter ? followed by a carriage return and the Help Menu will be displayed (see
below).
? - This Menu
EasyTalk Wireless Receiver V01.00.0X
Compiled: 12-Apr-12 at 15:38:51
Commands:
5101 - Get mute status
(00-off, 01-on)
5102 - Get volume (-16, 0 dB, 2-digit hex value: f0 is -16, f1 is -15, ff is -1, 00 is 0)
5110 - Get DRC enabled (00-disabled, 01-enabled)
5111 - Get EQ filter enabled (00-disabled, 01-enabled)
5112 - Get USB mix enabled (00-disabled, 01-enabled)
5113 - Get radio enabled (00-disabled, 01-enabled)
5120 - Get power on (00-off, 1-on)
6101 xx - Set mute status (xx: 00-off, 01-on)
6102 xx - Adjust volume 1dB (xx: 00-down, 01-up)
6110 xx - Enable DRC (xx: 00-disable, 00-enable)
6111 xx - Enable EQ filter (xx: 00-disable, 01-enable)
6112 xx - Enable USB mix (xx: 00-disable, 01-enable)
6113 xx - Enable radio (xx: 00-disable, 01-enable)
6114 xx - Enable factory defaults (x: 00-disable, 01-enable)
6120 xx - Power (xx: 00-off, 01-on)
6121 xx - Enable serial echo (xx: 00-off, 01-on)
? - Print command list
NOTE: commands 611x available only if DIP 7 up
Reponses:
4199 - Unknown command
4198 - Invalid argument
41xx yy - Successful get (5xxx), xx matches command, yy is returned value
4100 - Successful set (6xxx)