Vaddio EasyTalk Solutions Manual - Manual (Page 35)

EasyTalk USB Tools
Vaddio EasyTalk USB Solution - Document Number 342-0449 Rev B Page 35 of 48
EasyMic MicPOD User Controls
The EasyUSB Mixer/Amp audio can be controlled by user buttons on the EasyMic MicPOD in addition to the PC
controls described above. End-User audio controls include the speaker volume, microphone volume, and
microphone mute.
EasyMic MicPOD User Controls
Pressing the Answer button will answer an inbound call originating from the PC if supported by the
software application. The Answer button uses the On/Off hook function associated with Human
Interface Device (HID) commands on the device. If the application does not support this function, the
answer key will not be operable.
Pressing the OFF button will hang up the call originating from the PC if supported by the software
application.
Pressing the Mute button will mute all microphone audio being sent to the PC. The button will be
illuminated red when in the Mute state.
Pressing the top button will increase the loudspeaker volume. Pressing the bottom button will
decrease loudspeaker volume. The LED ladder volume level scale indicates the current level.
Pressing the OneTouch button will position a Vaddio camera to your location within the room. This
button requires the installer to program the camera preset with the hand held IR remote to function
properly.
EasyMic MicPOD
Echo Cancelling Table Mic