Vaddio HE120 Operating Instructions - Manual (Page 42)

42
Troubleshooting
  Operation
Symptom Cause and remedial action
Reference
pages
No power
  Is the AC adaptor securely connected to the AC outlet? –––
  If the power plug of the AC adaptor connected properly? –––
  If the unit is connected to the controller, has it been connected
properly?
 Refer to the Operating Instructions of the controller.
P.19 to 21
  When the unit is being operated by the wireless remote control
 Also refer to the “Cannot operate using the wireless remote control”
item.
–––
Cannot operate
( common to wireless
remote control,
controller)
  Is the power on?
 If the unit’s status display lamp is off or if it has lit up orange,
it means that the unit’s power is not being supplied.
<Operations and
Settings>
P.7
  The safe mode function may have been activated.
<Operations and
Settings>
P.89
  Have the limiter functions been set?
<Operations and
Settings>
P.87 to 88
  Has the correct unit to be operated been selected?
<Operations and
Settings>
P.9
Cannot operate using
the wireless remote
control
  Have the remote control’s batteries run down or have the batteries
been installed with their polarities reversed?
 If the status display lamp does not blink even when the wireless
remote control is operated near the wireless remote control signal
light-sensing area, it means that the batteries have run down.
Replace the batteries.
–––
  Have the IR ID switches been set correctly? P.36, 39
  Is there a fluorescent light or plasma monitor near the unit and,
if so, is the wireless remote control signal light-sensing area
exposed to its light?
P.34
Cannot operate using
the controller
  Is the unit connected to the controller properly?
 Refer to the Operating Instructions of the controller.
P.19 to 21
  The user authorization and host authorization must be set to OFF
when the AW-RP50 remote camera controller is connected in a
network. <Operations and
Settings>
P.75 to 76
  It may be necessary to upgrade the version of the controller so
that the controller will support the unit.
 Consult with your dealer.
–––
The unit turns in the
opposite direction to
the one operated
  Has the stand-alone (Desktop) installation setting been selected
correctly?
<Operations and
Settings>
P.48, P.73
  The reversal setting may have been established at the controller if
the unit is connected to the controller.
 Refer to the Operating Instructions of the controller.
–––