Vaddio HE120 Operating Instructions - Manual (Page 9)

9
Installation Instructions
How to install and connect the unit
(continued)
2
Mount the mount bracket onto the installation surface.
  Use the bracket mounting screws (M4, bind-head: 10 mm long) supplied with the unit.
  For proper clamping torque, securely attach the screws using the specified tools.
Screw diameter Clamping torque
M4 1.47 N · m {15 kgf · cm}
Bracket mounting screws  4 (supplied)
(M4, bind-head)
  Use only the screws supplied with the unit. Do not use any other screws such as wood screws, nails, etc.
Note
3
Attach the drop-prevention wire.
  Loop the circle part of the drop-prevention wire, which has been attached to the bottom panel of the unit, around the end
of the hook part of the mount bracket.
  Pull the drop-prevention wire, and check that it has been attached securely to the hook.
End of hook
Drop-prevention
wire
 Loop the circle part of
the drop-prevention wire
around the end of the hook
part of the mount bracket.
 Pull the wire, and check that
it is securely attached to the
hook.
  Do not do this work while holding the camera head since doing so may result in malfunctioning of the unit.
  The drop-prevention wire is designed to be used for installation where the unit is suspended from an overhead
surface so do not subject it to the weight of units other than the unit.
Notes