Vaddio Quick-Connect DVI-HDMI SR - Manual (Page 9)

Quick-Connect DVI/HDMI - SR Interface
©2010 Vaddio - All Rights Reserved. Quick-Connect DVI - SR Interface, Document Number 342-0045 Rev. A Page 9 of 12
Compliance and CE Declaration of Conformity
FCC Part 15 Compliance
• This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15, Subpart B, of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his/her own expense.
• Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept
any interference including interference that may cause undesired operation of the device.
• Changes or modifications not expressly approved by Vaddio can affect emission compliance and could void the user’s authority
to operate this equipment.
ICES-003 Compliance
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio
Interference Regulations of the Canadian Department of Communications.
Le présent appareil numérique n’emet pas de bruits radioélectriques dépassant les limites applicables aux appareils numeriques de
la classe A préscrites dans le Règlement sur le brouillage radioélectrique édicte par le ministère des Communications du Canada.
European Compliance
This product has been evaluated for Electromagnetic Compatibility under the EMC Directive for Emissions and Immunity and meets
the requirements for a Class A digital device. In a domestic environment this product may cause radio interference in which case
the user may be required to take adequate measures.
Standard(s) To Which Conformity Is Declared:
EMC Directive 2004/108/EC
EN 55022 A: 2006 + A1 2007 (CISPR 22:2005/A1:2005)
Conducted and Radiated Emissions
EN 55024: 1998 + Amendments A1: 2001 + A2: 2003 - Electromagnetic Compatibility - Immunity
EN 61000-4-2 Electrostatic Discharge
EN 61000-4-3 Radiated Immunity
EN 61000-4-4 Electrical Fast Transients
EN 61000-4-5 Surge Immunity
EN 61000-4-6 Conducted Immunity
EN 61000-4-8 Power Frequency Magnetic Field
EN 61000-4-11 Voltage Dips, Interrupts and Fluctuations
Warranty Information:
Hardware* Warranty - One year limited warranty on all parts. Vaddio warrants this product against defects in materials and
workmanship for a period of one year from the day of purchase from Vaddio. If Vaddio receives notice of such defects during the
warranty period, they will, at their option, repair or replace products that prove to be defective.
Exclusions
- The above warranty shall not apply to defects resulting from: improper or inadequate maintenance by the customer,
customer applied software or interfacing, unauthorized modifications or misuse, operation outside the normal environmental
specifications for the product, use of the incorrect power supply, improper extension of the power supply cable or improper site
operation and maintenance.
Vaddio Customer service
– Vaddio will test, repair, or replace the product or products without charge if the unit is under warranty
and is found to be defective. If the product is out of warranty, Vaddio will test then repair the product or products. The cost of parts
and labor charge will be estimated by a technician and confirmed by the customer prior to repair. All components must be returned
for testing as a complete unit. Vaddio will not accept responsibility for shipment after it has left the premises.
Vaddio Technical support
- Vaddio technicians will determine and discuss with the customer the criteria for repair costs and/or
replacement. Vaddio Technical Support can be contacted through one of the following resources: e-mail support at
[email protected] or online at www.vaddio.com.
Return Material Authorization (RMA) number -
Before returning a product for repair or replacement, request an RMA from
Vaddio’s technical support. Provide a technician with a return phone number, e-mail address, shipping address, and product serial
numbers and describe the reason for repairs or returns as well as the date of purchase and proof of purchase. Include your
assigned RMA number in all correspondence with Vaddio. Write your assigned RMA number on the outside of the box when
returning the product.
Voided warranty
– The warranty does not apply if the original serial number has been removed or if the product has been
disassembled or damaged through misuse, accident, modifications, or unauthorized repair. Cutting the power supply cable on the
secondary side (low voltage side) to extend the power to the device (camera or controller) voids the warranty for that device.