Vaddio WallVIEW CCU HD1 - Manual (Page 2)

WallVIEW CCU HD1
WallVIEW CCU HD1 Installation and User Guide 341-719 Rev. D Page 2 of 12
UNPACKING
Carefully remove and identify the following parts for the WallVIEW CCU HD1 system:
 One (1) - Sony EVI-HD1 High Definition PTZ Camera
 One (1) - Vaddio EZCamera Interface Module CCU (EZIM CCU)
 One (1) - Vaddio EZIM CCU to HD Break Out Cable
 One (1) - Vaddio Quick-Connect CCU Universal (1-RU Rack Mountable)
 One (1) - Vaddio HD1 Wall Mount
 One (1) - Sony IR Remote Control
 One (1) - EZCamera Control Adapter (RJ-45 to DB-9)
 One (1) - 36V PowerRite Power Supply with AC Cord Set
 One (1) - 2-position Phoenix Connector for Tally
 Mounting Hardware
 Documentation
 Vaddio Manual
 Sony EVI-HD1 Manual
Optional Accessory:
SD Break Out Cable, Part Number 440-6207-000
(Female BNC to Male RCA adapter not included)
Wiring Diagram Example:
Figure 2: The Quick-Connect CCU System uses a Cat. 5 (all 4-pairs) for power to ensure the motors receive the required
current to operate properly. The Video Cat. 5 cable uses all four pairs for video. The RS-232 Cat. 5 provides communication
to the camera for CCU and PTZ control and G/L (where applicable) to the camera. These Cat. 5 cables can be run up to 500’
(152.4m). See Appendix 1 for wiring and pin-out information. NOTE: A direct RS-232 Cat. 5 cable is required for each
Quick-Connect CCU and camera. Daisy-Chain configurations are not supported.
CAT-5 Cables
up to 500’
HD Break-out
Cable
EZIM CCU
Power
RS-232
HD or SD Video on CAT-5
RS-232 Tally
ProductionVIEW™ HD
HD VIDEO OUT (Y, Pb, Pr)
RS-232 IN
SD VIDEO OUT
G/L (Not Used)
POWER
Quick-Connect CCU
EVI-HD1 Camera, Wall Mount
with EZIM CCU
Component HD
+ G