Vaddio WallVIEW HD-19 - Manual (Page 10)

ClearVIEW HD-19
ClearVIEW HD-19 Manual 342-0266 Rev. B Page 10 of 24
Mounting and Installation Instructions for the CONCEAL Wall Mounting System:
Step 1: Determine Camera Mount Location:
When locating the camera, consider viewing angles, lighting conditions, possible line of site obstructions and
check for in-wall obstructions where the camera is to be mounted. Pick a mounting location to optimize the
performance of the camera. After determining the optimum location of the camera system, route the required two
(2) Cat-5e cables from the camera to the head-end.
The two (2) Cat-5e cables should feed-through a 1” (25.4mm) opening (circular or square shape) centered in the
rectangular slot located on the rear flange of the CONCEAL Wall Mount Bracket (see Fig. 1).
Note: Do not cut out the entire rectangular slot opening in the wall! This will not allow the two
lower wall anchors to correctly fasten the Conceal Wall Mount to the wall (see Fig. 1).
If the bracket is to be mounted on a 2-gang wall box, use the screws supplied with the wall box cover plate to
attach the CONCEAL Wall Mount Bracket.
If mounting to drywall with wall anchors, use the four (4) quality wall anchors/screws provided (see Fig. 1). Note:
The mounting holes are slotted and are 90° opposing to provide easy leveling. Level the mount and tighten the
mounting screws.
Note: Check all Cat-5e cables for continuity in advance of final connection. Plugging the
EZ POWER/VIDEO Cat-5e Cable into the wrong RJ-45 may cause damage to the camera
system and void the warranty!
Step 2: System Wiring
Follow the sample wiring diagram on the previous pages for connecting the Cat-5e cables to the camera and
Quick-Connect SR Interface. Additional diagrams are available on our website for installation with a variety of
videoconferencing codecs.
Step 3: Secure the Camera To the CONCEAL Wall Mount Bracket:
After all cables are attached to the camera, place the camera onto the camera mount and insert the two-(1/4”-20)
screws into the camera through the two-screw holes in the bottom of the mount. Note: Be sure to align each
side of the camera evenly to all sides of the CONCEAL Wall Mount Bracket before final tightening of the mounting
screws (see Fig. 2).
Fig. 1: CONCEAL Wall Mount Bracket:
Cabled and Attached to Wall
Fig. 2: Vaddio HD-18 Camera aligned
and attached to the CONCEAL Wall
Mount Bracket (by two-(1/4”-20)
screws in the bottom of the mount)