Vaddio WallVIEW HD-19 - Manual (Page 11)

ClearVIEW HD-19
ClearVIEW HD-19 Manual 342-0266 Rev. B Page 11 of 24
Step 4: Install the CONCEAL Lower Cover Plate:
Attach lower CONCEAL Lower Cover Plate (see Fig. 3). Slide lower cover plate from front of the mounting
bracket toward the rear of the bracket. The two-rear locking tabs will need to be guided into position first and will
lock in place as the lower cover plate is pushed toward the rear of the mounting bracket and the front tabs are
inserted (see Fig. 4).
Step 5: Install the CONCEAL Rear Camera Cover:
After successful testing of the camera, install the Conceal Rear Camera Cover on the CONCEAL Mounting
Bracket with the supplied screw (see Fig. 5 and 6).
NOTE (One more time!): Check all Cat-5e cables for continuity in advance of the final
connection. Label the Cat-5e cables. Plugging the EZ POWER HD VIDEO cable into the
wrong RJ-45 may cause damage to the camera system and void the warranty.
Step 6: Connect System Power:
Connect the Vaddio 24 VDC power supply to the Quick-Connect SR Interface and an AC outlet. Power will travel
down the Power/Video Cat-5e cable to the camera. The camera will “Home” to a centered position ready for
control information from the IR remote control or RS-232 camera controller of the integrators’ choice. To insure
proper continuity of control and operation of the cameras, the RS-232 controller (control system or joystick)
should be powered on after the camera.
Fig. 3: CONCEAL Lower Cover Plate
with Locking Tabs
Fig. 4: CONCEAL Lower Cover Plate
locked in place
Fig. 5: CONCEAL Rear Camera Cover
Fig. 6: Completed CONCEAL Wall
Mount Camera Bracket Installation