Vaddio WallVIEW HD-20 - Manual (Page 5)

WallVIEW HD-20
WallVIEW HD-20 Manual 342-0179 Rev. C Page 5 of 16
Quick-Connect SR Interface Rear Panel with Feature Call-outs:
1) Power Input:
5.5mm OD x 2.5mm ID coaxial connector for the provided PowerRite 24 VDC, 2.0 Amp power supply.
2) EZCamera Power & HD Video:
A single Cat-5e connection between the EZCamera Power & HD Video RJ-45 connector and the EZ Power HD
Video Port on the HD-20 camera extends power and video up to 100’ (30.5 m). Power is fed to the camera and
HSDS video is returned on the Cat-5e.
3) HD Video Output:
DE-15 connector outputs the YPbPr analog component HD video extended from the camera over Cat-5e cable.
SD video resolutions are not supported by the HD-20 Camera or the Quick-Connect SR Interface.
4) IR Output:
With the IR pass-thru turned on at the camera (see Camera Settings section), send IR from third-party IR remote
controls to third-party equipment, such as videoconferencing codecs. IR can be transmitted as either modulated
or non-modulated signals for added flexibility.
5) RS-232 Input & Output Jacks:
When using the IR pass-thru function, the IR signals are pulled from the Cat-5e RS-232 cable and delivered as
modulated and non-modulated signals to the IR Output ports.
INSTALLATION (Making things easier):
The WallVIEW HD-20 product was specifically designed for installation on a vertical wall surface with Cat-5e
cable connectivity for Power, Video and Control signaling (two cables are required). Installation is simplified in
that no custom 8-Pin mini-din cables or expensive coax plenum cables are needed and no power outlets are
required near the camera bracket. All cabling is routed to the head-end using Cat-5e cables.
Before Installing:
 Locate the camera mounting location paying close attention to camera viewing angles, lighting conditions,
possible line of site obstructions, and checking for in-wall obstructions where the camera is to be mounted.
Pick a mounting location that will optimize the performance of the camera.
 The CONCEAL Wall Mounting System for the WallVIEW HD-20 can be mounted directly to a 2-gang wall box
or can be mounted to the drywall using the supplied four (4) drywall anchors.
RS-232 Cabling:
For RS-232, use a standard Cat-5e cable and RJ-45 connectors (568B termination) from the RS-232 port on the
back of a Vaddio camera controller or switcher. If the camera is connected to a third-party control system (such
as AMX or Crestron), a DB-9 to RJ-45 control adapter cable is supplied. Use of pass-thru type RJ-45
connectors is highly discouraged. The Vaddio Cat-5e wiring standard uses pins 7 and 8 on both the
video and the control Cat-5e cables. The pass-through connectors have proven to provide insufficient
connectivity for these important signals. They are “ok” for voice and data, but not for video and control.
① ② ④ ⑤ ③