Vaddio WallVIEW HD-20 - Manual (Page 8)

WallVIEW HD-20
WallVIEW HD-20 Manual 342-0179 Rev. C Page 8 of 16
If the bracket is to be mounted on a 2-gang wall box, use the screws supplied with the wall box cover plate to
attach the CONCEAL Wall Mount Bracket. If mounting to drywall with wall anchors, use the four (4) quality wall
anchors/screws provided (see Fig. 1). Note: The mounting holes are slotted and are 90° opposing to provide
easy leveling. Level the mount and tighten the mounting screws.
Note: Check all Cat-5e cables for continuity in advance of final connection. Plugging the EZ
POWER/VIDEO Cat-5e cable into the wrong RJ-45 may cause damage to the camera system
and void the warranty!
Step 2: System Wiring
Follow the sample wiring diagram on the previous pages for connecting the Cat-5e cables to the camera and
Quick-Connect SR Interface. Additional diagrams are available on our website for installation with a variety of
videoconferencing codecs.
Step 3: Secure the Camera To the CONCEAL Wall Mount Bracket:
After all cables are attached to the camera, place the camera onto the camera mount and insert the two-(1/4”-20)
screws into the camera through the two-screw holes in the bottom of the mount.
Note: Be sure to align each side of the camera evenly to all sides of the CONCEAL Wall Mount Bracket
before final tightening of the mounting screws (see Fig. 2).
Step 4: Install the CONCEAL Lower Cover Plate:
Attach lower CONCEAL Lower Cover Plate (see Fig. 3). Slide lower cover plate from front of the mounting
bracket toward the rear of the bracket. The two-rear locking tabs will need to be guided into position first and will
lock in place as the lower cover plate is pushed toward the rear of the mounting bracket and the front tabs are
inserted (see Fig. 4).
Step 5: Install the CONCEAL Rear Camera Cover:
After successful testing of the camera, install the Conceal Rear Camera Cover on the CONCEAL Mounting
Bracket with the supplied screw (see Fig. 5 and 6).
Step 6:
Follow the sample wiring diagram on the previous page for connecting the Cat-5e cables to the camera and
Quick-Connect SR Interface, using a compatible Vaddio ProductionVIEW Joystick Camera Controller. Additional
diagrams are available on our website for installation with a variety of videoconferencing codecs, using the RS-
232 I/O connectors for IR signaling.
Fig. 1: CONCEAL Wall Mount Bracket:
Cabled and Attached to Wall
Fig. 2: Vaddio HD-20 Camera aligned
and attached to the CONCEAL Wall
Mount Bracket
Fig. 5: CONCEAL Rear Camera Cover
Fig. 6: Completed CONCEAL Wall
Mount Camera Bracket Installation
Fig. 3: CONCEAL Lower Cover Plate
with Locking Tabs
Fig. 4: CONCEAL Lower Cover Plate
locked in place