Vaddio WallVIEW PRO H700 - Manual (Page 3)

WallVIEW Universal PRO H700 Installation and User Guide 341-663 Rev. B Page 3 of 12
Daisy Chain Control Configuration:
The WallVIEW PRO H700 has provisions for daisy chaining control signals when using a RS-232 controller
with only one (1) RS-232 output. Each WallVIEW PRO EZIM has a RS-232 input and a RS-232 output (See
Figure 3).
MOUNTING INSTRUCTIONS
Step 1:
After determining the optimum location of the camera system, mark locations for the four screw holes and
cable pass-thru (vertical oval). Install the drywall mounts and cut the hole for the cable pass-thru. At this
point, do not install the Wall Mount.
Step 2:
Connect the 25-pin cable to the EZIM. Next, mount the EZIM
and break out cable on the back of the wall mount, using the two
tapped screw holes (see Figure 5).
Figure 3:
Daisy chain control configuration using two (2) WallVIEW PRO H700 systems and a single
RS-232 output control device. See Appendix 1 for wiring and pin-out information.
RS-232 Out
RS-232 Out RS-232 Input RS-232 Input
Figure 4:
Thin Profile Wall Mount with oval cable feed-
through hole. The wall mount may be
mounted directly to a 3-gang wall box or to
the dry wall with the appropriate wall anchors.
Figure 5:
25-pin connector mounted to
EZIM (left) and EZIM
mounted to the Wall Mount
(right)