Westwood Design Kingston Convertible Crib - Manual (Page 8)

Day Bed Conversion
A. Undo the eight bolts attaching the upper footboard to the sides and remove the upper
footboard. There are three bolts on each side, and two on the bottom.
B. If it's not already, adjust the spring to its lowest position, following the procedure shown in
these instructions.
C. Place the Footboard Conversion Cap (K) on the bottom of the footboard, thread the two
bolts into the fittings, and tighten.
D. Place the Right Day Bed Cap (J) against the right crib side (the extra two threaded inserts on
the side should face the inside of the crib as shown), thread the three bolts into the fittings on the
cap, and tighten with the allen wrench.
D. Repeat for the Left Day Bed Cap (H).
Left Day Bed Cap (H)
Right Day Bed Cap (J)
Undo two bolts here
Undo three bolts on
each side
Footboard Conversion
Cap (K)