Wittco 200-4R-BI - Manual (Page 7)

DRAWER & CHIP WARMERS F-41015 (03-14)
6
OPERATION
CONTROLS
The Warmer and its
parts are hot. Be very careful when
operating, cleaning, or servicing the
warmer.
The warmer Control Panel contains an
operating indicator light and a full range
thermostat. (Fig.2)
THERMOSTAT DIAL:
The thermostat also acts as the On/Off
switch to the warmer system. Turning
the thermostat counter clock-wise until it
stops will turn the warmer off.
POWER LIGHT:
The power light turns on and off as the
heating elements cycle.
POWER LIGHT
THERMOSTAT DIAL (Fig. 2) THERMOMETER
It is recommended that prior to placing the warmer into operation that it be pre-
heated at the highest temperature setting for a period of 30 to 45 minutes
.
OPERATING INSTRUCTIONS
The Warmer and its
parts are hot. Be very careful when
operating, cleaning, or servicing the
warmer.
Once the warmer has been connected
to the appropriate power source, the
warmer is ready for operation.
The warmers have one, two, three, or
four drawers depending on the model
purchased. Each drawer has a
separate thermostat dial and
thermometer.
Begin by turning the thermostat dial to
the number 5. This will cause the
heating element to start heating. When
this occurs, the red operating indicator
light will illuminate. This red light will
stay on as long as the heating element
is engaged. Once the predetermined
temperature is achieved, the heating
element will begin to cycle. During this
period, the red operating indicator light
will turn on and off as the heating
elements cycle.
The thermometer will begin to move and
indicate the interior temperature of the
drawer. (Fig. 3)