Wittco 700-CW - Manual (Page 11)

500 & 700 CHIP WARMER F-41160 (02-13)
10
TROUBLESHOOTING
SYMPTOM POSSIBLE CAUSE REMEDY
Chip Warmer not
operating
Chip Warmer not
plugged into power
source. Plug chip warmer into correct
power source as indicated on
serial data plate.
Lighted power switch not
in ON position. Press power switch to ON
position.
No power.
Check fuse and reset is
necessary.
Check GFCI switch on outlet.
GFCI or Ground
Fault Circuit
Indicator tripped.
Moisture problem. Dry moisture problem.
Damaged: element, wire,
power cord, etc. Contact Authorized Service
Provider.
Chip Warmer is
connected to
power source,
power is on, but
not heating.
Damaged: element, wire,
power cord, motor, etc. Contact Authorized Service
Provider.
Lighted power
switch is
illuminated, but
circulating fan is
not operating
Damaged fan, etc.
Contact Authorized Service
Provider
SERVICE & PARTS INFORMATION
To obtain Service and Parts information concerning this model, contact Wittco Service
Department at the address listed on the front cover of this manual or refer to our
website:
www.wittco.com for a complete listing of Authorized Service and Parts depots.
Customer Service 1-414-434-4713
Technical Service 1-414-434-4716
Service Parts 1-414-434-4716
When calling for service, have the model number and serial number available.